Audioscan Verifit User Manual download pdf (Page 53)

Verifit

User's Guide Version 3.12



May 2015

3. Highlight and <PICK> a stimulus type from the list box.

4. Highlight and <PICK> a stimulus level from the list box.

5. Highlight and <PICK> [Start test]

6. Highlight and <PICK> [Continue] to capture the comparison curve once the noise reduction function has

responded.

Feedback suppression test

This test shows the LTASS (upper graph) and the power concentration ratio (PCR) (lower graph) for a speech

signal. The PCR measures the degree to which a large amount of power is concentrated at a small number of

frequencies in the hearing aid output (see Freed & Soli in References). In the Verifit the PCR is the ratio of the

average power of the dominant frequency components in a 1/12 octave band to the power in the entire band,

expressed in dB. Because the gain of a compression hearing aid varies with the signal it is processing, the PCR

is calculated in real time while a speech signal is presented to the hearing aid. The upper graph shows the

LTASS for the speech signal while the lower graph shows the PCR relative to the PCR for speech without

feedback. Feedback results in a peak in the speech spectrum and in the PCR. Incipient feedback results in a

peak in the PCR curve.

1. Press <Tests>, then highlight and <PICK> [Test box measures] and highlight and <PICK> [Feedback].

2. Highlight and <PICK> Test 1 and select a level of 50 or 60 dB.

3. With feedback suppression off, force the instrument into feedback. This may be accomplished by placing the

monitoring headphones in the test box as shown (see Monitor headphones). With the test box closed, adjust

the monitor volume control until the feedback bar shows red during parts of the speech passage. Then press

<Continue>.

4. When the test has finished, peaks should be apparent in one or both curves.

5. With feedback suppression enabled, highlight and <PICK> Test 2 and select the same level used for Test 1.

Then press <Continue>.

6. The peaks in the curves of Test 1 should not appear in the curves of Test 2.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 154 155

No comments

Audioscan Verifit User Manual Page 53