Audioscan Axiom User Manual Page 14
- Page / 130
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Axiom
®
User's Guide Version 1.8
May 2015
connector panel. This connector must be used if a single monitor is connected. An additional monitor may be
connected to the second MONITOR connector.
9. When connecting both of the Axiom's monitor connectors to TV displays -- The set-up procedure should be
as follows:
1. Connect both HDMI cables.
2. Power on TV's & assign proper input on both
3. Power on Axiom & Wait 45 sec for boot up until splash/welcome screen would appear
4. Power cycle TV if video isn’t displayed
5. If video does not appear on either TV, first try power cycling the TV, then try re-booting the Axiom.
Failure to follow operating instructions could place the user or operator at risk.
WARNING: To avoid the risk of electrical shock, monitors connected to the Axiom must comply with
UL/IEC 60601-1 OR comply with UL or IEC and ISO safety standards for monitors AND a) be operated from
an isolating transformer complying with UL/IEC 6061-1 OR b) be kept at least 6 feet (1.8 m) from the patient.
10. Connect a USB mouse (included) to one of the USB connectors on either side of the Axiom.
11. Connect the Axiom power supply (included) to the power connector on the rear connector panel.
12. Connect the power cord (included) from the Axiom power supply to a GROUNDED electrical outlet. In the
USA and Canada, this outlet should be marked Hospital Grade.
WARNING: To avoid the risk of electrical shock, use only the power supply and power cord supplied with
the Axiom and connect it only to a grounded (protectively earthed) electrical outlet.
WARNING: To allow electrical power to be rapidly disconnected in the event of an emergency, position the
power supply in an accessible location so that the power cord may be quickly disconnected.
General care instructions
Probe tubes are for single patient use only. They may be wiped with alcohol wipes for re-use with the same
14
- Audioscan Axiom 1
- User's Guide 1.8 1
- Table of Contents 2
- 1 About Axiom 5
- Environmental safety 6
- Electronic User’s Guide 10
- 2 Getting Started 12
- General care instructions 14
- Microphone care 15
- 3 General Operation 16
- Barcode data input 17
- Screen messages and Help 18
- Software updating 18
- 4 General Setup 19
- 5 Networking 21
- Remote Operation 24
- NOAH Service Port 25
- Testing the NOAH service port 26
- 6 Single computer connection 27
- Storing data in NOAH 29
- Printing results 29
- Printing setup 29
- Printer connection 30
- Printer types 30
- HP printer 31
- Custom printer 31
- File output 32
- Page setup 32
- Network printer 36
- Web browser screen capture 36
- Session setup 37
- 8 Test Box Measures - Setup 40
- 1996 or 2003 ANSI standard 41
- ANSI test frequencies 41
- Test box calibration facts 42
- 9 ANSI Hearing Aid Tests 47
- ANSI test results 49
- 10 Other Test Box Measures 50
- Manual control procedure 51
- 11 Sensory loss simulator 54
- 12 On-Ear Measures - Setup 56
- Max TM SPL setup 58
- Positioning the client 59
- Positioning the probe tube 59
- SPL or HL scale 61
- Hide or show on-ear curves 61
- On-ear manual control 63
- 15 RECD measurement 64
- Measure RECD 65
- RECD results 67
- ANSI S3.46(2013) RECD 67
- RECD protocols 68
- RECD facts 69
- 16 Insertion Gain 71
- Insertion gain in HL 72
- Audiometric data entry 72
- REUR measurement procedure 73
- REAR measurement procedure 74
- 17 Speechmap 77
- DSL 5.0 changes 78
- NAL-NL1 in Speechmap 78
- NAL-NL2 in Speechmap 78
- Camfit in Speechmap 79
- Using Speechmap 79
- Speechmap Setup 80
- Screen tour - aided screen 83
- On-ear or Test box mode 83
- Speechmap screen choices 88
- Data entry 89
- Open fittings in Speechmap 92
- FM fitting and verification 95
- Speechmap stimuli 97
- Stimulus levels 97
- Microphone location effects 98
- Deep insertion compensation 99
- Speech signal analysis 99
- 20 Troubleshooting 100
- Test box speaker overdriven 101
- Invalid on-ear calibration 102
- Barcode scanner malfunction 103
- May 2015 104
- June 2015 105
- 21 Technical 106
- Specifications 106
- Sensory Loss Simulator 107
- 22 Glossary 109
- 23 References 114
- 24 Appendix 1 117
- 1 Introduction 119
- 2 The test signals 119
- 2.1 Narrow-band signals 120
- 2.2 Broad-band signals 120
- 2.2.3 Real-speech signals 122
Related products and manuals for Health and hygiene Audioscan Axiom
Health and hygiene Audioscan Verifit User Manual
(155 pages)
(155 pages)
© 2020, manymanuals.com. All rights reserved. | 5.599 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals